A2b ETX-200 Installationsanleitung PDF herunterladen (Seite 8)

4.3 EXM Web Control Interface

4.3.1 System menu

The following [System] menu

should appear when you connect

to the ETX-200. The [System]

menu contains basic information

about current settings and SW

options.

Menu buttons for [Input],

[Output], [IPTV], [Service

management], [CI] and [Upload]

are available at the top of the

menu.

4.3.2 IP address settings

The ETX-200 is set to an default IP address from factory (192.168.0.20 ). However, it

is possible to change the IP address and/or the Netmask and/or the Gateway. This is

an important function when you install two or more EXM units in a Head End and

want to connect all units together through a switch or a router.

4 Settings (continued)

Current settings

Contains information of current input and output signals, if the tuner is

locked to a signal, serial number and firmware revision.

Software options

Show what software options that are available in this unit (e.g. output

signal format, input signal etc.) See section 7 for more information.

System options

This menu contains current IP address for the ETX-200.

[Reset unit] gives a possibility to restart the unit at any time.

[System diagnostic]

By a click on the ”Download diagnostic file” you can save a file that you

can email to [email protected] for analysis if there is a problem with a unit.

English

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

A2b ETX-200 Installationsanleitung Seite 8